Dimensions:
Tub top dimensions: 36 x 21” (91 x 53 cm)
Tub bottom dimensions: 25 x 14.5” (63.5 x 36.8 cm)
Tub depth: 12.5” (32 cm)
Cart width w/ wheels attached: 34.4” (87.5 cm)
Collapsed dimensions:(as packaged) 38 x 26 x 16” (96.5 x 66 x 40.6 cm)
Balloon Wheels: 16.5 x 7.9” (42 x 20 cm)
Capacity:
Payload capacity: 220 lbs (100 kg)
Tub volume: 3.5 cbft (0.1 cbm)
Weight:
Weight w/wheels: 29 lbs (13 kg)
Materials:
Tub Material: High Density Polyethylene
Aluminum Finish: Marine grade anodized
Hardware: Stainless steel
Balloon Wheels: Polyethylene hub
Assembly directions:
1.Turn cart upside down.
2.Slide axle through axle mounting bracket.
3.Just before pushing axle through last mounting bracket, make sure the three gray prongs are spread to let axle enter.
4.Slide axle through to line on axle.
5.Slide wheel onto axle with valve stem pointed outward, insert quick clip pin and rotate pin ring over axle.
6.Slide second wheel onto axle and fasten.
7.Pivot cart prop slightly more than a quarter turn until it latches in place against rear side of cart.
8.Turn cart right side up.
9.Release handle clamps by flipping release tabs to opposite position.
10.Move handle to desired position and flip release tabs back to original position.
11.Load items into cart.
12.Retract prop by pressing latch with hand and pushing prop cross bar with foot (near center) to snap into up position.
13.To set prop, reach down and grab cross bar in hand and pull upward until latch locks prop in place.
14.To Disassemble: Remove wheels and reverse above instructions.
Maintenance Tip: To prevent rusting, rinse all parts with fresh water and dry.